Enable/Disable AutoSSL using Admin Tools

If you would like to reinstall your AutoSSL Certificates you can do so using our Admin Tools following these steps:

  1. Connect to your server using SSH
  2. Run the following command: 
    /root/init
  3. Select [4] Admin Tools
  4. Select [13] Lets Encrypt SSL - Enable
  • 4 Users Found This Useful
Was this answer helpful?

Related Articles

There is not enough space on this disk to backup the MediaCP and contents

While performing a backup (either automatic or manual) you may encounter the error message below:...

Differences between MB, GB and MiB, GiB

MediaCP uses a digital metric of units when referring to data size. In this case 1 (GB) Gigabyte...

OpenVZ virtualization

During the installation or upgrade of MediaCP you might receive the following notice: ERROR:...

Unable to access MediaCP on port 2020

There are typically only two reasons why the Media Control Panel is inaccessible: The mediacp...

Cannot login to the MediaCP with valid credentials

If you are unable to login to the MediaCP then there could be several reasons: Captcha...